Eurostamp / Rolla-V tooling replacement

What is the Eurostamp / Rolla-V tooling system?

Eurostamp / Rolla-V supplies tooling under the Rolla-V rolling die systems. If your machine is already equipped with this system, replacement tools are specified to match it — the tang geometry, the working height and the retention method all have to agree, not just the nominal size.

How are Eurostamp / Rolla-V catalogue numbers structured?

Eurostamp is associated with the Rolla-V rolling die concept, where the die shoulders roll rather than slide during bending. Because Eurostamp does not publish a public part number index, identification is normally done from the tool markings and the die rail type rather than from a catalogue number.

• A catalogue number identifies the profile; it does not replace measuring the tool.
• Worn or reground tools keep their number but lose working height.
• Where a brand publishes an official decoding key, that key is authoritative — not third-party guesses at what the digits mean.

What should I send to identify a replacement?

If your catalogue number is not listed, send us the number together with a photograph of the tool and a ruler shot of the tang. We will confirm the system, angle, radius, height and segment length before you order.

1. The catalogue number stamped or laser marked on the tool.
2. The angle and tip radius, if legible.
3. The working height from shoulder to tip.
4. The total length and any segment combination.
5. A photograph of the tool and of the tang with a ruler in shot.

Related technical pages